How to Mix Gas and Oil for Your Weed Eater Trimmer

It is only common sense to run the engine of a car with the right fuel. Just imagine what would happen if you run your car with a diesel gasoline or if you use a 9-volt battery to operate a D-cell flashlight. Not only will they said item not work, there is also the possible of ruining the material or engine. In the end, you might have to suffer through a lot of hassle and even pay for expensive repairs.

It is only natural that you look for the right type of fuel to use, especially when you are planning to start up your weed eater trimmer. Using the right type of fuel will guarantee the high performance of your weed eater. Not only will the right type of fuel make your weed whacker operate efficiently, it also keeps it safe. To keep your engine running long and strong, please read below.

Learn How to Properly Mix the Fuel

Step 1: It is highly recommended that you start with reading your manual. You can get additional information regarding the fuel mixtures and fueling if you read the instruction manual. The information on the product will help you determine what kind of fuel to use and what mixture to adopt. There may be cases when you have misplaced your instruction manual so you just have to contact your manufacturer to get another copy of it.

Step 2: You also have to check whether or not you are using the right container for your engine. When it comes to the container of gas for the weed whacker, you have to use the approved ones. There are containers specifically designed for containing gasoline in weed eater trimmers. A good example is the No-Spill fuel container. The said container is specially designed for reducing evaporation, permeation, and spillage.

Step 3: Consider going premium. If you are choosing what gasoline to use for your weed eater trimmer, going with the cheap stuff can prove to be fatal later on. You should avoid going with what you find cheapest.

Step 4: For the mixture, it is oftentimes recommended for the owners to use a mid-grade unleaded gasoline. The recommended minimum octane rating for the said gasoline you will use in the mixture is 89. The fuel that has a lower octane rating has a higher chance of increasing engine temperature. If the engine temperature increases, then there is an increased risk of the piston experiencing seizure. The possibility of causing damages to the engine is quite high too.

Step 5: Another recommendation to take note of is the use of the STIHL premium quality two-cycle oils. This is the kind of oil specifically designed for delivering the highest level of protection for your engine.

Step 6: Take note that all of the STIHL gas-powered equipment takes advantage of the 50:1 gasoline-to-oil mixture. If you are using one gallon of gasoline, then you need 2.6 fluid ounces of oil. If you are using 2.5 gallons of gasoline, then you need 6.4 fluid ounces. The 50:1 gasoline-to-oil ratio works this way.

Step 7: Pour the oil first into the canister. After that is the time to add the gasoline. Once done, you can close the fuel canister. Do not forget to shake the canister by hand. That way, you can ensure that the oil is mixed properly with the fuel.

Step 8: Before you pour the mixture into the engine’s gas container, you should clean up the fuel cap as well as the area surrounding it. Doing so prevents dirt from falling into the container. Position the machine with the cap pointing upward. If you do this step, you can reduce the chances of direct contact to fuel as well as inhalation of fuel vapor. The fuel cap should be removed carefully to easily allow pressure build-up inside the tank, if every there are any, to slowly be released.

Step 9: Mix fuel sufficient enough for a few day’s work only. Storing fuel should be okay if the time frame is less than three months. Also, if you are going to use fuel mixture that has been stored away for a certain period of time, shake the canister well before fueling.

Add a Comment

Your email address will not be published. Required fields are marked *