How to Use a Weed Eater

Lots of homeowners wish to have beautiful landscapes in their lawns, their gardens, and their yards. To achieve such goals, they are taking care of these areas by performing certain actions. One of them is to trim down the weeds that are growing in the surfaces. These weeds, especially those that have grown untamed and unwanted, need to be trimmed down, if not completely removed. They are usually considered as pests since they make specific areas unpleasant.

To conveniently remove these weeds, a tool such as a weed eater would be very useful to any homeowner. There are three main types of weed eaters that you can find in the market. A weed eater may be an electric type, a battery powered type, or a gas powered type. Typically, most products, especially devices and machines, come along with manuals where the user can see and follow the instructions on how to operate such things. In this case, you should always refer to your manual first. Here are the general steps on how a weed eater that you have can be operated.

  1. With the help of the manual, you should familiarize yourself first with the buttons and the controls of the weed eater that you have, whatever type or model it may be. This way, you can easily follow the step by step instructions on how to operate it. You will also be able to identify and push the right buttons whenever you will start doing the weeding task.
  2. You also need to make sure that you also know the safety measures associated with utilizing this device. You should make sure, too, that the attachments and guards of the tool are all secured properly.
  3. Before you start your task, you must be checking out the area first. If there are objects that might damage the string of the weed eater or might be thrown by it, they should be removed. Pets and other persons should be restricted from the area while you work to avoid accidents. You must not start up the weed eater inside any building or closed area.
  4. You need to ensure your safety whenever you will be using this tool for your weeding task. For this matter, you should be wearing protective gear for any weeding project that you will be doing with a weed eater. Protective gears may include eye protection, closed-toes shoes, gloves, long sleeves, and long pants. At times, the weed eater might throw some debris towards you, such as stones or even poison oak and other toxic plant fragments. The gears will protect you from the injuries that the debris may cause. Ear plugs can also be used if you are using a gas powered weed eater.
  5. You will need to start the machine up. For a gas powered type, you should be pressing the primal bulb several times as recommended by the manufacturer so that gas will flow to the carburetor.
  6. Afterwards, you should turn it to full choke. Then, you need to squeeze on the throttle and pull the string. This step should be done after you put the weed eater on the ground.
  7. The choke then need to be set to the middle position. The throttle should be squeezed and the string pulled until the engine starts. If it does not start, you just have to let it sit for several seconds and try pulling the string again. Once the engine starts running, you should be turning off the choke completely.
  8. You should be picking up the weed eater with one hand on the throttle and the other hand on the assist handle. You should be holding the throttle for about thirty seconds or even a minute. This action will get the engine of the machine warmed up.
  9. You must be keeping the tool at waist level when you start weeding and the attachment must always be parallel to the ground. It is recommended to trim weeds from side to side so that debris will most likely not go flying towards you but you can also use the forward and back motion.
  10. The tip of the line should always be used when trimming. Heavy cuts should not be forced as it will overload the engine.
  11. Once you are done, you just need to release the throttle and leave it idle for several seconds. Afterwards, you just press on the off control button. Before you store it, you should let the engine cool off.

One Response

  1. Sarah September 24, 2016 Reply

Add a Comment

Your email address will not be published. Required fields are marked *