How to Rebuild a Weed Eater Carb

Weed eaters are used by people to trim and cut the weeds that are growing in the gardens. Typically, these weeds are grabbing nutrients intended for the floras that these individuals, themselves, have intentionally planted. This is one of the main reasons why they are considered pests and need to be trimmed and cut down. Another reason is that the beauty of the gardens or the lawns are destroyed by the presence of thick and untamed weeds.

A weed eater is composed of different important parts. For your weed eater to properly function the way it is supposed to, you should make sure that all of these components are in good working condition. One of them is the carburetor or what is referred to simply as the carb. The function of the carb is to provide the proper amounts of air and fuel mixture to the engine of the weed eater. If your carburetor does not work, it would be more practical and cheaper to rebuild the carburetor than to buy a new weed eater or send the machine to a repair shop. Here are the steps on how you can rebuild your weed eater carb.

Step 1: The first step is to purchase a replacement carburetor or a rebuild kit. You can actually buy this kit for a certain amount yet the price will surely be way cheaper than buying a new trimmer or sending it in for repairs. There are a lot of establishments that sell such kit. You can go to the nearest hardware store in your area. You may even place an online order for a carb on a specific website. Wherever you will be purchasing this component, you should make sure that you will only be making your purchase from a reputable seller. This way, you can assure yourself that the item will work once you attach it to your own weed eater.

Step 2: You should make sure that the rebuild kit that you will be purchasing is compatible with the model of your weed eater. Otherwise, it will not work. Two types of rebuild kits are available in the market. The first type only has the diaphragm gaskets while the second type has all replacement parts together with the diaphragm gaskets.

Step 3: A rebuild kit typically consists of a wide variety of small sized components. These components are general items. This means that each of them are applicable to three or four models of carburetors. They are not utilized specifically for only one model. With this, you may notice later on that there will be a couple of parts that you will not be needing.

Step 4: On the back side of the carburetor, you will see the primer bulb being held in place by four small screws. Using a screwdriver, you should remove these screws. You must make sure that you will temporarily place them in an area where you can easily notice them.

Step 5: After unscrewing the screws, the diaphragm gasket will fall out. This is the part of a carb that usually and commonly gets damaged. You should be checking this part. It does not have to be replaced if it nice and soft. If it is brittle and easily snaps, replacement is necessary.

Step 6: Afterwards, you will also need to remove one more screw to check on the push valve and the floater. These items may also need replacement so that your weed eater will be working properly. A push valve or floater that is bent needs to be replaced. Those parts that are also showing discoloration or any other sign of wear and tear should also be replaced.

Step 7: You should make sure that the surfaces of the carburetor are clean. Dirt may hinder the carburetor from performing its function. You can use a clean cloth as well as a carburetor cleaning solvent.

Step 8: There are various holes in the carburetor. Specific and small sized parts will fit inside these holes, such as the floater and the push valve. You should make sure that you will be properly placing the small parts inside the holes. There is also a spring that needs to be placed inside a specific hole. You should make sure that you will be putting it in straight because if not, your weed eater will definitely not work.

Step 9: After placing all the parts in their right places, you need to screw them back with the screws that you have removed earlier. You should make sure that all the screws are screwed tightly.

Add a Comment

Your email address will not be published. Required fields are marked *